Originally Posted by MoH-Zee
Hi guys please help
connecting heartbeat cable HD PVR and SD PVR
Where does the cable go for the HD PVR RF in or RF out?
Also the communication port in the HDPVR settings should it be set to RF in or RF out?
It depends on your actual installation see the installation sticky as C4 suggests
(a) The SD PVR CAN ONLY be the Secondary AND it can only receive HBs via the RF OUT port so on the SD PVR the setting is Communications port = RF OUT
(b) The HD PVR therefore has to be the PRIMARY if paired with the SD
If you choose to use the RF IN port then Communications Port = RF IN
If you choose to use the RF OUT port then Communications Port = RF OUT
BTW when you contact call centre and they start asking you about your installation, DO NOT TELL THEM you have used the RF OUT port because they will immediately refuse to proceed with the activation - just lie to them and say it is RF IN.
"Bandwidth, or more accurate, Data Rate, is a commodity, not a value added service"
Easyview, UEC 4T HD PVR, SD PVR, XV
Spare decoders: SD PVR(2), PACE HD PVR 4T, DSD 660, 1110, 1131
Win 10 Pro (64-bit) build 1511, version 10586.104